M15x1.0 Threading Alignment Tool (TAT) Die Starter for 7.62mm - Gunsmithing

works great!

good but could have been better with a harder material

Bought this as recommended by Amazon for the mosin nagant muzzle break. As others have mentioned it is soft aluminum so prone to damage. Secondly the threading isn't very good and need to be further cut. Third, it does not fit securely into 30 cal muzzle. Threaded my muzzle twice with this, both times were far off parallel. This tool does not align anything. Save yourself the trouble and buy a good one for seven dollars from CNC Warrior.

haven't been able to use it yet as the threading die I purchased here to use with it, will not thread onto it, no way to check it for proper threading as no machinist thread gauges availabe for the required thread pitch!!! May have to visit a gunsmith to compare!!!

Fits 7.62 correctly good luck finding the die.

It lines up the die but there is no way to hold it from spinning as you turn the die.

I was finally able to shoot my mosin, and the threads were off. terrible terrible terrible. Buy the one from CNC warrior. had to cut the barrel even shorter now because the threads were off.

junk i hate it and the threads were coated too thick in chrome. this made it hard to run the tap over and the ends of the threads were damaged.