RV Designer E223, Plastic Grab Handle,8 3/4 inch, Black, Entry Door Hardware, 1 Count (Pack of 1)

Purchased and these were great. Performance, durability and fit was spot on!

They came in early, installed easy and looked nice. Good quality.

Really, I'd give it about 3.7 stars, if you could do partial stars, as for the money; it is a very good value. I purchased it intending to use it as a grab handle on a UTV, as the handles marketed for UTVs are very pricey, and this was just over $6, or around 1/10th the cost. I'm not sure if I'll use it for the UTV b/c it is a little flimsy for that. For its intended use as a handle to assist in getting in or out of a camper, I'm sure it would probably work very well. It isn't heavy duty, but for a budget handle, I can't complain that I didn't get my money's worth. Johnson's Surplus Store shipped it quickly, no problems with the seller.

Good

Handle worked great to replace the nasty old one on our travel trailer. Seems durable enough if mounted securely to Rv structure.

This is a really nice handle for the price. I've installed a couple of them on my van, one on the side door and another on the partition. So far they're holding up fine and they look good too. I am slightly concerned because it's 100 percent plastic (no metal reinforcement of any kind) so am not sure how it will do long term, especially in really cold weather when the plastic might get brittle but so far, so good. Also, I did install flat washers under the screw heads to prevent the screws from digging into the plastic when tightened. I think these should have been included but that's certainly not a big deal.

I hope that the manufacturer reads this review and changes its screws. The handle is plastic and a soft plastic at that. The screws supplied with the handle have a small diameter head. That head can pull through the soft plastic when a heavy force is applied like in trying to arrest a fall. There are several solutions: Supply screws with bigger heads that will fill the entire recessed mounting hole. Alternately supply washers to distribute the load and keep it from pulling through. This is what I did. I think that with the original screws it is a very flawed product and can be dangerous.

I like the outdoor durability of this handle far more than a metal one. Choose the right method of anchoring and you've got a long term handle solution that looks good.

Easy install just a couple minutes and you’re good to go. I recommend. Thanks.

It fit exactly as described and looks great. It is sturdy and strong.

We bought this grab handle for the outside of an RV outside door. The handle seems sturdy, but unfortunately no screws were included with the handle. So it's a bit of a problem finding aluminum screws to fit the holes on the handle. Hopefully the company will send us some.

Super poignée qualité et format parfait

Used it for side door on my trailer. Matches the rear door handles. Simple enough.