Broan-NuTone PM300SS Custom Power Pack Range Hood Insert with 2-Speed Exhaust Fan and Light, 300 Max Blower CFM, Stainless Steel, 21-Inch Built

Replaced our old vent hood. I love how this works and looks. The high speed is a little noisy but it lights the whole area well and works very well. It was pretty easy to install.

Finally got around to installing this insert in an existing hood. Install went quick and easy, have been enjoying for several months. Lights are bright, fan is strong. High-fan is loud but it moves some air, great for when you burn something. Low-fan is perfect for normal cooking. Moving just enough air to pull smoke, steam, fumes up and out but quiet enough to enjoy a conversation while you cook. If I had the need, I would buy again.

Got it to replace a hood vent that was 24 years old. Arrived in perfect condition. Took some figuring to get it in correctly as the older cabinet was not built like expected but got it in and it looks great. Also nice bright lights, and fan is pretty powerful. Fairly loud but it’s ok because it is moving the air as it should.

Great for a custom hood!

Perfect fit to replace my old one.

Great direct replacement for an older model. Easy install, no modification needed. Great lights. High speed fan is a little loud.. overall great product.

So, I liked that I was able to achieve this look as my place came with the microwave/bent combo that I am not particularly keen on. But mine came with 2 fan settings (Low and High), and the fan, though powerful, is very loud!!! If anyone has any ideas on how to limit the noise of the fan, please share! I added insulation since mine is ductless to help drown the fan, but to no avail. It looks like, I’ll be only using the low fan, even though it’s loud, it’s less loud than the high setting. If it wasn’t so loud, I would give this a 5/5! Also needed to buy other parts for this too.

I found this replacement for an old Nu-Tone exhaust insert. The old unit had a smaller cut-out in the cabinet, so I used a jig saw to cut a larger opening. That takes a little carpentry skill, but wasn't too hard. Next, the new unit has little wings that allow you to push the blower assembly up through the bottom of the cabinet and "snap" in place. Then you add four screws to finalize the installation. Next came the re-ducting of the exhaust. This was the most difficult part, as the old duct was not the same size as the blower exhaust port. I used tin snips to cut relief slits around the perimeter of the duct, then bent things until the parts mated together. You will need a roll of aluminum tape to seal everything. The new unit has great LED lights and the blower is very efficient. The low speed is rather quiet but the high speed makes a good bit of sound. We are very pleased with the overall look and use of this range hood insert.

Sleek, works well, good lighting.

Suction is little less

the fan switch is broken. didn't even last a year!

So ordered this range hood for mini kitchen Reno. It may work fantastic don’t know. May never know. We need parts to install and apparently cannot get parts for this unit. Very very frustrated. DO NOT BUY!!!!!

It is extremely difficult, if not impossible, to connect with Broan Customer Service - to ask the simple question of 'what kind of non-duct recirculation kit fits the Broan Nutone PM300SS range hood? For the poor customer service, I have rated the product only 1-star and will likely return.