Thick CA Glue - TotalBond Cyanoacrylate Super Glue Adhesive for Wood, Stone, Brick, Plastic, Glass, Metal, Epoxy and Crack Repair - 2 oz

Solid option for CA glue. It's definitely thicker than regular super glue, so sticks and fills small voids well.

I tried a LOT of glues to use on my ceramic bird feeders. I need to attach a ceramic bead to a 1mm braided stainless wire. The bead supports the whole unit which is typically about 1 to 1.5 lbs so the bond needs to be very strong. Epoxy tends to be messy and it can be hard to get the correct proportions to obtain a decent bond, not to mention the sticky mess. E6000 is a flexible bond and does not hold up at all for my needs - despite several attempts. Many CA adhesives (i.e. super glue) are too thin and can be difficult to control. They also tend to dry out in the container before I can use them up so I've often had to toss the rock hard tubes, sometimes even before they were opened. This glue, finally fit my need for a super strong, weather resistant, clear bond. The liquid is thick enough to fill the 1.5-2mm bead hole without running through and it dispenses quite well. It takes a few minutes to set up, providing some working time, and I had a solid bond when I checked it a few hours later. I tested it by gluing a bead on the wire, wedging it between my feet and pulling as hard as I could. I will be back for more.

This stuff is amazing!!! This is what Krazy Glue USED to be back in the day. All super glue sucks these days unless you can hold the piece that you are trying to glue in place for 2 or 3 hours. This stuff bonds in mere seconds to a minute. The applicator is also made to not get clogged. This medium consistency is perfect in my opinion. Very free flowing but not too runny.

Really good stuff. Together with the accellerator it will create a strong bond in seconds. Only small downside. The lid can get stuck, so make sure you clean the tip surface as often as possible to prevent that. Until now, when it has happened, I've been able to open the bottle with the help of a small pliers.

I use it for small wood projects and it works really well. It holds well but the bond can be broken if really needed. Cures quickly on its own, and instantly with the accelerator sold separately.

Used it to glue together the seal corners of my RV's slideout. Had tried many different glues to no avail. This one works!

Wish the tip was a little more precise, like the glue but “medium” flows a lot from the factory tip. Can’t imagine thin.

Easy to use