Waterproof Cover for RFID Access Control Keypad Fingerprint Access Controller Rainproof Cover Sell Protector Door Lock Security System

EXCELENTE

This worked with my Liftmaster "MyQ" outside keypad but I had to make some modifications to it. It is also wider than my threshold for my side garage door and overhangs a bit. I used masking tape on the back of my keypad to mark the mounting holes on it. I transferred that masking tape to this cover and using the marks I made, marked the cover. I drilled a top and bottom hole in the cover back. Then I used Dremel to cut a slot on the top hole that mimicked the hole/slot of the top hole of the keypad. The keypad goes on a screw, over the screwhead and then slides down a slot. So now that both mounting holes matched, I used the marked masking tape again on the door threshold where I was mounting it. Marked the two hole locations amd pre-drilled holes. It mounted easily with the keypad and cover going on the top screw first and sliding down the slot into position. The bottom screw was then put in. It all worked. Rock solid. It overhangs width-wise on my threshold but still looks and functions as it should.

Bought this as backup in case the one I have in used protecting a doorbell wears out. Not sure the first one will ever wear out.

Works well but isn't perfect. Covers any small part and had to hole to fit my deadbolt. Covers top but in direct Arizona sun, I fear it won't be enough coverage.

It's simple and does the job!

The cover is good and durable.

I bought this for my google door bell. My house faces west, so the google door bell overheats and shuts down. I bought this to keep the sun out. It works, but it drastically limits the sight of the door bell. Oh wells, atleast I have a door bell.

Worked great for the keypad I bought. Be prepared to drill the holes needed to match up with your keypad's mounting hole pattern. Nice tall top helps protect from the sun and also helps to show people where the keypad is.

I installed these on steel sign posts I drive into the ground and mounted my motion sensors in the cover. I had to drill a couple holes in the cover to mount the sensor attachment bracket. Easy to do and works great.

what can you say!!!!

Got this for little more rain cover for my shed plug . Simple solution. Hard plastic. Just what I needed. Used it to be a simple rain cover for my shed plug

Thought it was aluminum. Oh well!

Perfect size to fit over my Google Nest lock. Required a little customization but it was easy to do. Easy to install and provides the weather protection that I was looking for .