Loctite Power Grab Ultimate Construction Adhesive, ultimate strength adhesive, 0 second instant grab, high tack adhesive, No-nails and screws, no clamping, no mixing, metal, tiles, wood, concrete 440g

I sticked a huge 3ft x 4ft cabinet on my bathroom wall with this construction adhesive without any nails and it did the job. The cabinet was heavy. And its hanging strongly. 5Star

The polymer binds very well, as claimed. However, without a plunger, very difficult to get the polymer out and leads to wastage and breakages

Dries like a toothpaste, weak like a dry toothpaste and doesn’t stick anything.

THIS IS A FRADE PRODUCETE BETTER IS TO BUY FEVICOLE SUPER GELL PLEASE DO NOT INTRODUCE THIS PRODUCT I had to loose money

This product does not work as promised.

This stuff is the bomb! I searched all over for a product that could be used to bond fiber reinforced panels to a welded steel garage door frame. This worked great under tough conditions. I can't speak to the normal time to set but, even in proper temperature conditions, I think this material will require clamping to hold on vertical surface.. I did not use it in anywhere near optimum (or even recommended) conditions. I used this on the frames of an exterior garage swing door and did so last April in record cold. Nights were in the high 20s Fahrenheit. Daytime highs of no more than 55. I could not close the doors due to the clamps. I do not recommend this application environment and doubt the manufacturer would either. However, this stuff dried to a tough, slightly pliable bond within 24-36 hours. Again, no idea of set time in proper conditions. I also applied the FRP to older steel with a significant patina of rust. I did use an angle grinder to remove a couple of sections of heavier scale, but that's it. This stuff grabbed tight. I got about 90 feet of medium bead per tube and used the excess for a variety of other applications including bonding plastic (polyethylene) and veneer to plywood. Great stuff!

We used it for styrofoam ceiling panels. It worked excellent. A little thick to pump out t worded

Tube needs to be put in HOT water for about 30 minutes before it will flow out of tube.

I was bonding aluminum-to-aluminum and aluminum-to-PVC, both non-porous materials, so I did a lot of research on construction adhesives and found that most of them require at least one of the two mating materials to be porous in order to adhere properly. This one does not require that -- it specifically states that it will bond two non-porous materials. Cure time to full strength will be slower though. I watched a lot of construction adhesive review materials where various presenters try to determine the relative bond strength of different brands of construction adhesive. I found most of those experiments are flawed in one way or another. For example many just wait overnight, despite the fact that this adhesive and several others can take days to reach full strength. Other videos test with some rod cantilevered out of a glob of construction adhesive, ignoring the fact that that is not how you should use construction adhesive and most applications are going to apply compression and sheer forces (not "pull-out" leverage where an object is twisted out of the joint). I think all construction adhesives are about the same strength, and if the joint coming free is a major concern, you are probably misusing construction adhesive and should consider using mechanical fasters or epoxy.

Excellent adhesive. Works as advertised.