180Pcs Tactile Push Button Switch Assortment Kit, 10 Values 6x6mm 4-Pin Micro Momentary Tact Switch Set

This set was better than expected. The switches are better quality than I expected and work well. The spacing fits well into breadboards. The replacable color caps is a nice touch. I did notice that the caps do not stay on well. A dab of glue helps with finish projects. You get a LOT of switches for the money. Highly recommended.

Had a malfunctioning Garage Door Remote. Determined was the micro-switches that had just simply worn out. Decided to buy a new remote. $29! What? So, went hunting for three micro-switches to effect repair. Could not find anything other than this "Kit" which had what appeared to be the right size switch amongst the myriad of selections. At $6, couldn't go wrong. Arrived quickly and installed easily (I do have soldering skills). Work perfectly and now have a bazillion extras for any future projects. A huge win and $6.00 repair, saving me $23 over a new remote. Couldn't be happier! Celebrated with a couple of beers and a shot. All good!

Great selection of miniature push button switches but with 10 latching ones as well. The push button have 9 different stalk lengths which help provide options when mounting the switch in the device so that it can easily be pushed. Except the latching ones they are typically off and are only on when pushed and held in. Typically used as a reset button or maybe a push to light button, they could also be used as an alarm trigger. This is a good selection at a very good price in a sorted compartment plastic case.

The buttons are all the same type you receive in your generic arduino or rpi kits. The bounce is minimal but does vary from piece to piece. Pros: Cheap, quality buttons Fit well into .1 inch center breadboard/perfboard Cons: Don't fit/stay well in .1 in center prototype board. You have to be careful leveling them while soldering

I really only needed one button but these were at a good price and I wasn't sure of exact size. I used the correct one and my shredder works great again. I then gave some to a friend for his projects and I have spares and others I can use for various projects

These are great and there’s lots of them! The colored buttons fit very securely on the switches. And the 12x12mm footprint fits on 0.1” matrix boards.

Excellent product

Appear to work fine if being soldered onto circuit or proto boards. However, contact legs are too flimsy for breadboard projects. They often bend prematurely but even when they don't the switches remain loose and continually fall out of the breadboard

Nice kit.

came in early, realy happy with quality.

Lo uso para modificar gameboys y reparar electronicos (teles/radios) de los botones de canal y radio que nunca encuentras en steren o alguna otra electronica. Muy buena variedad de medidas.

Llegó a tiempo y tal como lo anuncian, lo recomiendo ampliamente.