Sewell Ghost Wire Termination Block, 4 Pack

Have not yet installed it so I am just rating the price and the delivery process.Much more expensive per foot than competing brands but reviews suggest that it is better quality. The terminal blocks cost more than the wire, and I had to buy 12 to get 10 for 5 wires.Delivered when promised. Not keen on the usual Amazon practice of dropping the parcel on the porch without even ringing the doorbell.

These worked perfect. You just have to make sure when you add the copper tape that you ensure the conductor terminals are pressed into the copper to provide a better signal. Don’t just lay the tape in the conductors. I will buy this product again.

Great easy setup, perfect to transfer signal. Recommended

Purchased these with the flat wire with four leads. It is not easy to feed the flat wire through while down by the baseboard because the "door" that you feed the wire through must remain opened in order to screw the terminal to the wall. You cannot pre-attach the flat wire then attach the terminal to the wall. Also, they are not setup for 4 lead wires. You need two termination blocks on each end. With four leads, you have to split the tape with the leads, but the termination blocks have the mounting screws where the other set of leads goes, either above or below. If they are going to sell a four lead wire, the termination blocks should be setup similarly to allow for either a single termination block with two sets of leads or with a design to allow each to be mounted separately without interfering or potentially screwing through the other set of wires.

Years ago I installed flat speaker wire for surround sound and had jury-rigged a solution. I looked again at some speaker solutions and found these. The flat wire I have is not this brand, but the connectors work perfectly.1. What's in the box? You receive 4 of these connectors.2. Install and use?: These are basically tiny boxes (about the size of your thumb) with two holes for conventional speaker wire (and any screws - be sure not to simply open these as they are usually loose!) which tighten down. The flat wire is installed while the shutter is open. Once you put the wires inside you simply close the shutter and create a perfect connection.The boxes have screws to place these on the wall, but I simply placed these in a electrical box and these work fine with that as well...Perfect. If you have flat wire, this is certainly a terrific solution to making seamless connections.