10Sets USB C Male Type-C Connector DIY Solder Data Cable Power Plug

Items were packaged well, all parts were there and no flaws. You will need a small tip low power soldering iron. All components fit good. Easy to assemble and functions well. Fits receptacles good. A great value for the money.

I have installed these as power supply for wifi cameras and they are working well. The pads are large enough to solder without any special procedures for 18 GA wire. The only improvement would be a stop inside the shell to keep the connector from going too deep.

As advertised, functioned as it should was only using for broken charging cables and they work just fine you will have to use a little glue on the housing to keep them together. They were ship nicely and arrived on time. All pads took solder with out no issue they where pre tin.

Excellent product

I used 4 of these USB-C cable ends, soldered to existing cables (used to shorten cable to the needed length). None of these worked. I soldered the ends on to two existing cables that previously worked fine. I cut the cable to shorten it to the length needed, and soldered the ends on the same way as the original. I tried 4 pieces, none of them worked.

Exactly what I ordered, small as expected but not terrible to work with. You get more than I ever hope to have to replace so a good value for the money.

With only 4 leads these connectors can't support usb 3.1 functions. This is only suitable for 2.0 as high speed charging and data transfer require that 5th lead. I'm sure it works great if slow charging and data fit your needs.

Thanks