3M Super 77 Multi-Surface Spray Adhesive, 14.1 oz

This adhesive is great. READ instructions carefully including to ventilate the room) I used it for affixing some postcards (after trimming) to heavy duty card stock (and envelopes). It is important to know that the postcards and paper card stock are able to take the adhesive without causing curling or being overpowered by the adhesive. I put a large plastic bag as a base protection for the table I was working on. You need a clean sheet of newspaper for each spraying as this stuff is very sticky. I laid the postcard on the newspaper and sprayed lightly per the instructions. You have to be very careful of placement on the cardstock ahead of time, as there is literally no room for errors as pulling the sprayed item off the card stock to readjust does not go well. You have about 10 seconds to get the sprayed item onto the card. Once item is on the card, I put a piece of waxed paper over it and rolled it with an old rolling pin to make sure the card has been pressed evenly. In all, I made over 30 cards (and still have more to go), and only messed up one card which I had to toss. So, I would give this five stars in that it did what I wanted and now I have an assortment of blank cards to use for many occasions ready to go. The postcards I bought are all different, including floral designs.

What can I say. If you want and good adhesive go with a 3M product. This spray adhesive applies easily and works. I was applying sound absorbing padding inside speakers. It tacks quickly and holds tight. Perfect for the DIY.

I bought this spray adhesive to glue together laminated vertical drape fabric panels that separated when they were laundered. The glue was easy to apply, and struck a good balance between stickiness and ease of use. A single can covered approximately 4,000 square inches (100" x 5" x 8 pieces) with a small amount left over. I applied the adhesive to one surface, laid the other part on top, and applied pressure. It was easy to re-position when not perfectly aligned, and there was no visible excess adhesive afterwards. The biggest downside was the overspray. I used my kitchen island to stage the 100" long panels, and possibly due to air flow from my AC vents the glue spray traveled much further than I expected. Therefore I'd recommend masking at least 8 feet in all directions from your workpiece. Cleanup was a bit painful because of the extent of overspray, but isopropyl alcohol and paper towels did the job. Overall, I would definitely recommend this product for similar light duty applications.

Good value that does the job. Stinks for just a bit. Dry is slower. I tried to get away with using it on concrete walls and it didn’t work very good at all but I kinda guessed that.

So far I bought it, used it and love it! I used it to turn crocheted baskets into hanging planters and this worked great connecting the plastic and cloth! Now how it will hold up I don't know but so far I'm impressed. Wear gloves lol I"ll be picking glue off my fingers for a week though. And it does have blow off so might wanna use some kind of covering for the area where you are working. I am spontaneous and don't think of things like that until after the fact, so there ya go!

This stuff more than delivers. Learn my lesson -- you only need a little. It's VERY sticky. I needed to apply a decal to a golf cart. The decal measures about 4x10 inches. I lightly sprayed it, and stuck it onto a clean surface. I did not spray the surface. I had plenty of time to wiggle it around to make it straight and push out any bubbles. I was concerned that I hadn't used enough spray, since other reviews had mentioned how quickly it dries. Nope. After a couple of minutes, I tested a corner. Stuck down firmly. Pro tip: If spraying a relatively small piece of something, place it on a piece of cardboard. Then there are no worries that you are getting overspray on a surface that doesn't need it.

It's pretty good quality, but the amount you get per can is very expensive at this price point. I would consider buying again, but there are other budget friendly options that will work just as well.

Works well

Way way too expensive but it works for holding high density foam for an ATV seat rebuild.

3M garantía de calidad. Producto practico y confiable.